Ingersoll Quad Drill
7/08/10
Cut Cycle Time in Half with the
Ingersoll Quad Drill 
KM's Chris Wynstra teams up with Lake Country Corporation to demonstrate how the Ingersoll Quad Drill can cut cycle times in half.  Watch the Quad drill perform in steel and stainless steel on a CAT40 machine. (More)

_______________________________________________________________________________________

Big Kaiser Boring Heads
5/27/10
When a Conventional Approach just won't work,
Big Kaiser and KM find Innovative Solutions
KM and Big Kaiser provide a customized solution to a long reach boring application at AAA Sales and Engineering. The result proves successful for both AAA and their customers. (More)

_______________________________________________________________________________________

Sumitomo Metal Slash Mill
4/15/10
Boost Productivity with Sumitomo
Metal Slash Mills  
KM sales representative, Carey Stencil takes a look inside two successful applications using the Sumitomo MS Feed Mill. Current users rave about the mills ability to increase tool life and amp up productivity. Hear one customer's success story. (More)

_________________________________________________________________________________________

Iscar PCD Milling Insert
2/18/10
50% decrease in cycle time, 33% increase in tool life. 
Find out how they did it.
Take a look at how Guy Pentimalli and Pioneer Products teamed up increase their productivity and tool life with the Iscar PCD milling insert.  (More)

________________________________________________________________________________________

Carmex Multitooth Threading Insert
1/7/10
Save Time, Save Money with the Carmex Multitooth Threading Insert 
Looking to save money and time on your threading applications?  Let the multitooth inserts from Carmex do the job!  The multitooth inserts are available in a variety of threads and grades. (More)

_________________________________________________________________________________________

Nachi VG Oil Hole Drill 3D/5D
and SG-Low Spiral Taps
12/17/09
Extended Tool Life
The VG Oil Hole Drill 3D/5D ran at one of our customers in Appleton WI and the closest competitor was half the tool life! The SG-Low Spiral Taps were run at a customer in Michigan and tap life was more than 10 times the closest competitor! (More)

__________________________________________________________________________________________

Double Sided Swiss Tools
12/3/09
Double Your Tool Life with Double Sided Swiss Tools- Can be run on any machine!
Kyocera has developed a double sided negative insert that has a sharp cutting edge equivalent to a positive insert edge.  You can have all the benefits of a positive geometry and the economy of a negative geometry.  (More)

__________________________________________________________________________________________

FG Chip Breaker
10/29/09
Have you struggled breaking a chip
in 1045, 1018 or DOM Tubing? 
Look no further, KM Tool Supply has found a solution. Six of our customers had this problem until we brought in the “FG” chip breaker from Ingersoll Cutting Tools.  The “FG” chip breaker coupled with the 5100 grade has provided a problem solving tool that is sure to impress you. (More)

___________________________________________________________________________________________

5 Second Insert Change by Click Change Tool Holders
10/15/09
5 Seconds and you're done!
Want to change an insert in 5 seconds, have longer and more repeatable tool life and not worry about hardware again? Watch the video! (More)